Download
Software
The system software for the electronic sewing machine (PLK-E Series)
The latest version of the system software for the electronic sewing machine (PLK-E Series) can be downloaded.
- The file format is "LHA self-extracting".
- After downloading, expand the file on the execution disk.
- Please defrost after executing download, copy onto floppy disk (F1-F4), and use it.
- Please make it to pasting the label to the floppy disk of F1-F4, and the record of "Number" and "Version".
- The system of the previous version must not exist together and never use it.
- This software is the latest PLK-E Series system software.
Please read the manual of the attachment well for the setup each model. We will recommend the thing to take the backup to return it to a present state before reinstalling is executed.
It is strongly recommended to make a backup before reinstalling so that the current state can be recovered.
Data Name | Size | Note | |
---|---|---|---|
F1 | esys231.exe | 297KB | System data |
F2 | esys232.exe | 205KB | Graphic data |
F3 | esys233.exe | 80KB | Picture data |
F4 | esys234.exe | 363KB | Font data |
Change history
Version 23
- Revised Function output after halt switch was pressed.
- Revised basting function concerning 12.7 mm stitch length in JOG mode.
Version 22
- Revised displayed message when Chinese font is used.
Version 21
- Improved stability for pattern selection by using Bar-code reader.
- Revised problem >> If needle position is deviated from UP position in home return procedure, clamp motion becomes unstable.
- Revised problem >> When needle position setting is set down at pressing halt switch, and count up control is enabled, clamp and needle is not controlled correctly.
Version 20
- Revised problem >> Pattern data which includes point data and curve line data can not be modified occasionally.
- Added setting which selects needle bar motion at home return procedure.
Version 19
- Revised clamp start timing after presser foot goes up in pattern modification mode.
- Enhanced pattern selection function for Bar-code reader.
- Revised count up state control function concerning stitch number counter.
- Improve stitch feed parameters for PLK-E3040 (Improve maximum sewing speed).
Version 18
- Improved stitch feed parameters for PLK-E1008H (Improve motion stability).
- Added default setting data for PLK-E2008H.
- Added default setting data for PLK-E3040.
- Revised function for saving I/O customized data.
- Added function which prevents needle up automatically in home return procedure.
- Revised saving function for BA pattern data (pattern no.400 to 599).
- Revised problem >> If needle position is deviated from UP position in home return procedure, machine stops and needs power switch off.
- Revised problem >> When needle position is not UP position, there is a possibility of interfering between needle bar and presser foot.
Version 17
- Revised home correction function.
- Revised modification function for BA pattern data (pattern no.400 to 599).